Accuracy Systems Gunsmith Services and Custom Finishes
Here are some pictures that speak louder than words about our custom gunsmith services.
You compare our workmanship and products to other Mini conversion companies and you decide.
- Competitors Bedding: Sloppy and prone to cracking, will breakdown over time. Still relies on trigger guard to hold action in the stock
- Accuracy Systems, Inc. Bedding: Clean looking! We use three steel pillars (∗ see above) epoxy into the stock. Then we use three steel screws to bolt the receiver to the stock.
Now you can take your receiver out as many times as you like not effecting the bedding and it always remains strong - $95.00.
C. Competitor's target crown. Notice that the crown is not sharp and crisp. The barrel also looks like the end of a baseball bat.
D. Our 11° target crown is sharp and crisp. This is a must for accuracy! The muzzle also looks more like a gun barrel.
| Gunsmith Services |
| Re crown the barrel while still in the action |
$40 |
| Re crown the barrel requiring the use of the lathe when the barrel must be taken out of action then reinstalled. |
$175 |
| Shorten & re crown the barrel |
$125 |
| Remove the barrel from the action to cut and re crown. |
$250 |
| Turn the barrel Outside diameter down while the barrel is out of the action.. |
$150 |
| Remove the barrel from the action and turn down the out side diameter using the lathe. Then re install the barrel. |
$250 |
| Correct the head space |
$175 |
| Re throat & barrel set back for accuracy |
$175 |
| Flute the barrel after the front of the gas block when the barrel is being made. |
$150 |
| When barrel is out of the action Flute in the front and in the back of the gas block |
$200 |
| Remove the Barrel from the action for fluting and re install the barrel in the action after fluting. |
$250 |
| Thread The Barrel for a muzzle brake, suppressor or flash hider when the barrel is already removed. |
$100 |
| Thread the barrel that must be removed from the action and then be reinstalled. |
$160 |
| Bed Action / Three point steel pin bedding |
$95 |
| Trigger Job - Match performance. Very short take up. No creep! Very crisp pull. With take up adjustment screw installed. |
$65 |
| Re install the factory front sight |
$50 |
| Test target and range test / 1 box ammo |
$132 |
| Hourly machine rate |
$100 |
| Hourly shop rate |
$75 |
| Fit the stock to barrel & action |
$100 |
| |
| Custom Finishes |
| Custom Finishes |
Complete Rifle |
Electroless nickel, satin finish
|
$225 |
Hard chrome, satin finish (Steel Parts Only)
|
$225 |
Parkerized finish (steel parts only)
|
$225 |
Black Oxide (steel parts only)
|
$175 |
| Anodized (red, dark blue, green, black) Aluminum parts only |
$225 |
| |
